Product Overview

The Nomad Wings Extreme is a high-performance 5G, 2X2 MIMO cellular, omni-directional antenna designed for enterprise environments, both indoors and outdoors 🌐. It delivers 2X data speeds across the full 600 MHz to 6 GHz 5G spectrum, making it ideal for boosting cellular coverage in retail, office, or outdoor spaces🏢🌲. With its minimalist design and small footprint, the Nomad Wings Extreme offers high-capacity throughput with a discreet aesthetic.

The IP54-rated antenna can be wall or pole mounted 🛠️ and comes with low-loss cables to ensure maximum performance and router optimization 📈.

🧰 Required Tools

• Phillips Screwdriver
• 5/16” Torque Wrench (5 in.-lb)
• 7/32” Drill Bit
• 7/16” Wrench
• Loctite or 3M Red 271 Thread Locker

⚙️ Mounting Options

🔸 Wall Mount: Suitable for indoor installations 🏠. Use the provided mounting bracket and screws to secure the antenna to a non-metallic wall.

🔸 Pole Mount: For outdoor or pole installations, mount the antenna to a vertical pole with a diameter between 1.5 inches and 2.5 inches using the provided V-bolt, saddle clamp, and hardware 🏗️.

📝 Placement Considerations

📍 Omni-Directional: Ensure the antenna is mounted properly to maximize the 360-degree horizontal coverage.

⚡ Interference: Keep the antenna at least 24 inches away from electrical devices like lights, routers, and AC units to avoid signal interference.

🧱 Signal Path Loss: Avoid obstructions such as concrete walls or metal objects that may absorb or reflect the signal.

🔌 Cable Length: Use the shortest possible cables to reduce signal loss. Avoid bending the cables sharply.

🔧 Installation Steps

Pole Mount:

1. Choose a location with a clear line of sight to the nearest cellular tower📶.
2. Attach the mounting bracket to the back of the antenna using the four thread-forming screws.
3. Mount the antenna to the pole using the provided V-bolt and hardware. Tighten the nuts with the 7/16" wrench, ensuring the antenna is securely fastened 🔩.

Wall Mount:

1. Use a stud finder to select a stable location. Drill two 7/32" holes into the wall, ensuring the area is free of metal obstructions 🛠️.
2. Attach the mounting bracket to the antenna and fasten it to the wall with the provided screws 🔧.

Cable Routing:

1. Route the antenna cables to the router, ensuring no sharp bends. Secure the cables approximately 6 inches below the antenna using UV-resistant cable ties for outdoor setups 🌞.
2. Waterproof the RF connectors using electrical tape or heat-shrink tubing for outdoor installations 💧.

Cable Connection Instructions

1. Clean the connectors using canned air or isopropyl alcohol to remove any dust 🧼.
2. Connect the antenna cables to the designated terminals on the router:

• CELL 1 to MAIN0
• CELL 2 to AUX0/DIV

🔍Commissioning & Testing

• Confirm that all coaxial cable connectors are secure and that there are no sharp bends in the cables 🔄.
• Use a cellular device’s built-in diagnostics to verify an RSSI signal strength higher than -75dB 📊.
• Ensure the cellular connection supports the required data rates for optimal performance🚀.

⚠️ Safety Warnings

• Maintain a minimum separation of 20 cm from the antenna to comply with RF exposure requirements 📏.
• Avoid installing the antenna in windy conditions or near power lines to prevent serious injury 🌬️⚡.

📞 For further inquiries or support, contact Nomad Internet Support at support@nomadinternet.com ✉️.

Updated on: 09/27/2025